Re: Autopano Pro converting RAW

On Apr 1, 10:23 am, Father McKenzie <father_mcken...@[EMAIL PROTECTED]
> wrote:
> Accidentally took 2 shots meant for this panorama in RAW instead of JPG
> large.
> PTGui wouldn't open them but Autopano Pro did it no problems.
>
> http://www.flickr.com/photos/silvermoon/2377167816/sizes/o/
>
> A little noisy but it was a long exposure just on dusk.
> I think it is time to clean the sensor looking at the top left corner.
>
> --
> Father McKenziehttp://www.flickr.com/photos/silvermoon

Hi
When making a PANO in a 3 : 1 ratio use the Golden section rule. The "
third" rule is just not up to it when you compare.
Move the end of the line to the centre and it will get better and more
dramatic

Also get some drama going by increasing the saturation of the sunset
gold. and darken down the top and base of the picture to make some
simple improvements.
Any noise can be removed by shooting at lower iSO and geting the right
exposure.
IT can e a mistake to blame the long exposure.

Burnt out highlights and blocked up shadows are a product of poor
exposure and lack of contrast control. Not "digital"
 A very nice iamge

Rod
www.da-vinci-vision.com