Home printing suggestions

Ok, so I found an Omega B-22 with safelight, timer, lenses, neg carriers
and 
a couple of 11x14  trays for $75.

I'll be doing both fiber and RC so need some ultra-economic ideas (both 
cost-wise and space-wise) for wa****ng, squeeging and drying.

Homegrown solutions for wa****ng?
Convert a leaky aquarium, set up a tray washer, buy a used vertical
washer, 
or ?

....for squeeging?
Necessary?  Or just get as much water off as possible while holding the 
print?  Or get some stainless steel sheet or plexiglass to lay the print
on 
for squeeging?

....for drying?
Can 8x10 fiber prints be hung?  Or do they need to be laid flat?  I've
seen 
suggestions on my past posts for grabbing various plastic trays from a
place 
like Target.

Thanks for all your suggestions on home developing and printing these last

few weeks.  Some of this is probably pretty tedious to the veterans here.

Greg
-- 
Fun bicycle ride in the middle of nowhere:
http://lodesertprotosites.org/pokerrun/pokerrun.html

Dethink to survive - Mclusky