Re: Some simple questions about Single-Tray Processing

"David Nebenzahl" <nobody@[EMAIL PROTECTED]
> wrote in message 
news:47bdb8ff$0$27629$822641b3@[EMAIL PROTECTED]
> On 2/21/2008 7:59 AM Steven Woody spake thus:
>
>> Thanks for you advices.  How much a print drum will cost?  Do you have
>> some suggested brands?  Thanks again.
>
> Beseler/Unicolor. Used. Look on eBay; they're pretty cheap. (You need
the 
> drum and the motor base used to rotate it. Forget doing it by hand.)

With all due respect, you don't NEED a roller base. But now that I have
one, 
no way am I giving it up!

I have problems with the drum 'walking' to one side or the other as it 
rotates. I've tried adjusting the leveling screw, but can't seem to get it

right. Any suggestions? My current solution is to just have it walk to one

side and set a container there to stop it from going further.