Re: Some simple questions about Single-Tray Processing

I've heard of some folks placing large rubber bands around both ends of the

drum close to the rollers to keep the drum  from drifting.  Dunno myself -
I 
do the manual rolling back and forth, varying the angle and duration of
the 
rolls.

"Ken Hart" <kwhart1@[EMAIL PROTECTED]
> wrote in message 
news:fpkgb5$v6v$1@[EMAIL PROTECTED]
>
> "David Nebenzahl" <nobody@[EMAIL PROTECTED]
> wrote in message 
> news:47bdb8ff$0$27629$822641b3@[EMAIL PROTECTED]
>> On 2/21/2008 7:59 AM Steven Woody spake thus:
>>
>>> Thanks for you advices.  How much a print drum will cost?  Do you have
>>> some suggested brands?  Thanks again.
>>
>> Beseler/Unicolor. Used. Look on eBay; they're pretty cheap. (You need
the 
>> drum and the motor base used to rotate it. Forget doing it by hand.)
>
> With all due respect, you don't NEED a roller base. But now that I have 
> one, no way am I giving it up!
>
> I have problems with the drum 'walking' to one side or the other as it 
> rotates. I've tried adjusting the leveling screw, but can't seem to get
it 
> right. Any suggestions? My current solution is to just have it walk to
one 
> side and set a container there to stop it from going further.
>