Re: Some simple questions about Single-Tray Processing

In article <r7Yvj.40484$w57.25161@[EMAIL PROTECTED]
>,
 "Dudley Hanks" <hanks.dudley@[EMAIL PROTECTED]
> wrote:

> "Ken Hart" <kwhart1@[EMAIL PROTECTED]
> wrote in message 
> news:fpkgb5$v6v$1@[EMAIL PROTECTED]
> >
> > "David Nebenzahl" <nobody@[EMAIL PROTECTED]
> wrote in message 
> > news:47bdb8ff$0$27629$822641b3@[EMAIL PROTECTED]
> >> On 2/21/2008 7:59 AM Steven Woody spake thus:
> >>
> >>> Thanks for you advices.  How much a print drum will cost?  Do you
have
> >>> some suggested brands?  Thanks again.
> >>
> >> Beseler/Unicolor. Used. Look on eBay; they're pretty cheap. (You need
the 
> >> drum and the motor base used to rotate it. Forget doing it by hand.)
> >
> > With all due respect, you don't NEED a roller base. But now that I
have 
> > one, no way am I giving it up!
> >
> > I have problems with the drum 'walking' to one side or the other as it

> > rotates. I've tried adjusting the leveling screw, but can't seem to
get it 
> > right. Any suggestions? My current solution is to just have it walk to
one 
> > side and set a container there to stop it from going further.
> >
> The processor I have uses a motor driven arm that goves back-and-forth
as 
> well as the circular motion.  In this way, it gets the chemicals moving
from 
> end to end in the drum as well as circulating the picture.
> 
> Also, the drum attaches to the arm via a magnet, so hook ups are quick,
so 
> your timings stay consistent.
> 
> It's a great system.
> 
> Take Care,
> Dudley

Its a Jobo :)

-- 
Reality is a picture perfected and never looking back.